Its not surprising that your craftsman has been through h*ll and back, and is still working In my oppinion, ANYTHING made by craftsman is awesome quality, from their basic wrench, to their power drills!
I have recently eased my way into installing ductless/split AC systems. I have been using a Craftsman 19.2 V drill for driving screws and hole sawing 2-5/8" holes. The drill has been doing pretty well for a $100 drill but I do run into situations often enough when I putting holes in old...
I know this is an old thread, but I have recently acquired a 14.4v right angle craftsman from a friend who lost the charger. I have several craftsman drills that are 19.2.
I have,,,,,, Armstrong Craftsman Craftsman Pro Carlye Cornwell klein Gearwrench SK Snap-on Wera IMO the best bang for the buck are the craftsman Pro. These are the same as SK and Armstrong. To me ease of warranty is a big factor as screwdrivers are something I can tear up...
A few years ago I bought some Craftsman power tools that use the 19.2 2.0Ah rechargeable batteries. At the time of purchase the salesman told me to always keep the batteries charged and charge them once a month.
Hi All, I just inherited a 1x24 Craftsman belt sander model 113.22570 (circa 1974). I'm looking for two accessory options they made. Called ereplacementparts.com (official Craftsman parts site) but they did not carry those accessories. Google didn't result in anything, either. disc attachment #9-22573 table attachment #9-22574 Any ideas appreciated, thanks! Pete July 7, 2020 4 replies All ...
I recently acquired an older Craftsman table saw, model 113.295752. It's a direct drive, ten inch, lighter duty, home workshop type saw. My problem with this saw is here's a 3/8" rod that protrudes about four inches out the back side of the table, right smack in the way of the rip fence rail. The maybe two foot long rod runs just under the table surface, about an inch left of the blade. I can ...
Hey there, I acquired a craftsman table saw Craftsman 113.298090 Motor: 62962 from a friend who said it worked perfectly two years ago but had been sitting in his garage since then. When I fired it up for the first time, it began smoking and it smelled like plastic or electrical burning...
I bought a used craftsman 6" jointer. Ran fine for a few times but this past week I ran one board through it fine and turned it off for a minute. When I tried to turn it on again, the motor hums but does not spin. The motor and the blade assembly spin freely by hand. I took the motor off the...
